USE IS RESTRICTED TO 12-VOLT NEGATIVE GROUNDELECTRICAL SYSTEMS. 07/03INSTRUCTIONS FOR THE INSTALLATION OF THE ELECTRIC POWER TRIM GAUGE ARECONTAINED HEREIN. Power Trim GaugeInstallation InstructionsInstruction Sheet #0 515 010 451Rev. Phone: 1-80Tools and Materials Needed For Installation:16 Gauge stranded, insulated wireNon-insulated Вј' spade connectors, female2 В№ в‚Ѓв‚†' hole sawDrill and drill bit setHalf-round fileTape measure or rulerSmall tools: wrench or nut driver, utilityknife, pliers, etc. The warranties herin are in lieu of any other expressed or implied warranties, including any implied warranty of merchantability or fitness, and any other obligation on the part of VDO North America, or selling dealer.(NOTE: This is a Limited Warranty as defined by the Magnuson-Moss Warranty Act of 1975.)Siemens VDO. VDONorth America assumes no responsibility for diagnosis, removal and/or installation labor, loss of vehicle use, loss of time, inconvenience or any otherconsequential expenses. On any part or product found to be defective after examinationby VDO North America, VDO North America will only repair or replace the merchandise through the original selling dealer or on a direct basis. Provisions of this warranty shall notapply to a VDO product used for a purpose for which it is not designed, or which has been altered in any way that would be detrimental to theperformance or life of the product, or misapplication, misuse, negligence or accident. Thiswarranty applies to the first retail purchaser and covers only those products exposed to normal use or service. #158 or equivalent)VDO Spin-Lok ClampLight DiffuserInstallation Instructions111111Diagram CProper wiring of the Power Trim GaugeSiemens VDO Limited WarrantyVDO North America warrants all merchandise against defects in factory workmanship and materials for a period of 24 months after purchase. The sizeof the mounting hole must be nolarger than 2.1' Be aware of this ifyou intend to cut a new hole for thegauge.Item Description1.2.3.4.5.6.Г™QuantityPower Trim Gauge(2 В№ в‚Ѓв‚†' diameter)Lamp Socket (Push in, wedge-type)Light Bulb (12-volt / G.E. Connect the appropriate positive ( ),ground (negative ), and signal wires tothe gauge and gauge lamp socket as shownin Diagram C.CAUTION!!!Parts ListThese instructions contain information about a 2 В№ в‚Ѓв‚†' gauge. Insert the gauge and secure it with theVDO Spin-Lok Clamp. Select the location for the instrumentand cut a 2 В№ в‚Ѓв‚†' hole. YWXdCgYdSX6ecU2 hCgYdSXUT !'f7b e T7b e T2QddUbiD ?5 Q eVQSdebUbDbY] CU TUbGauge Installation:Wiring the Gauge:1. If in doubt, please contact your dealer or VDOInstruments at 1-80. Alwaysdisconnect battery ground before making any electricalconnections. вћЉDbY] BeTTUb cYdY 9 TYSQd bBEGIN HERECAUTION:Read these instructions thoroughly before making installation.Do not deviate from assembly or wiring instructions.

Sso usa siemens vdo